4v DC to 220V AC inverter circuit

4v DC to 220V AC inverter circuit with Mobile charger transformer

4v DC to 220V AC inverter circuit

In this simple electronic project I have clearly shown how you can make 4v dc to 220v AC with mobile charger transformer, we are going to construct a very simple low power inverter.  We have used some components/elements to make this electronic project. Even this electronic project/circuit can be made with scrap components available at your own home. An inverter circuit/project is used to convert the DC [ Direct current ] current to AC [ Alternative current ] current. You can make this project without any hesitation but it is an experiment circuit it can be used for commercial purposes.

There are two types of inverters

1True/pure sine wave inverters.
2Quasi or modified inverters.

Pure sine wave inverters are costly & arent easy available while modified or quasi inverters are very easily available and cheap mean less expensive.

Modified/quasi inverters produce square wave and these are not used to power pure types of equipment. On the other hand, Modified square wave inverters use transistors and transformers to produce AC current from DC current.

In this electronic project/circuit, we have made very simple inverter that can b used to glow the AC LEDs bulb of 1 watt however its power can be increased/maximized if you rewind the transformer from yourself.

Components Required

1✪. Transformer: cellphone mobile charger [ 6 points ].

2✪. Transistor: 13003 to 13005.

3✪. Resistor 10Ω to 30Ω [ Ω symbol of Ohm ].

4✪. Capacitor 400v 2.2uf or 4.7uf.

5✪. Battery: 4volt.

6✪. Led bulb: 220AC maximum 10w.

The points which have maximum resistance will take for output and other points can be used as input points according to the circuit diagram.


You can use any NPN transistor and we have used D13003 to 13005 NPN transistor in this electronic project circuit.

points of D13003 Transistor points are shown in the circuit diagram shown.

1.5v to 220v inverter

The circuit diagram is presented there you can use it with 1w led bulb only

Final Project of 1.5 to 220v AC


  1. In your diagram you have the polarity of the capacitor reversed to how you actually built it in the video.

  2. Get a gauge of how much the whole interaction will set you back. A few organizations might give you a modest gauge before the work is begun. In any case, whenever it is done you might be accused of extra expenses. https://www.wtfixair.com.au/